LOCATING YOUR WINE CELLAR
Read the “USE and CARE” guide before you start !
LOCATING YOUR WINE KOOLR SERIES WINE CELLAR
Provide 2 1/2 minimum clearance for both sides and back; keep the top clear.
Never locate your wine cellar outdoors or in an area with extremes of temperature and humidity. These units must be 50%R.H.).
Outlet power must be a DEDICATED separately fused, grounded, 15 Amp 110 – 120 V line or 7.5 Amp – for 240 V models
(CHECK BOX OR SERIAL NUMBER LABEL ON UNIT FOR YOUR LINE VOLTAGE REQUIREMENTS).
KoolR Products will not be liable or responsible for incidental or consequential damages.
Place unit in a clean area and allow access to the exterior surfaces for periodic vacuuming of the condenser coil.
Clean using a damp cloth and no detergents or polishes under any circumstances.
Always remove all bottles before relocating your wine cellar.
AREA FOR ASSEMBLING YOUR WINE CELLAR:
choose a clear 12′ by 8′ area with a level floor. Place soft material underneath to avoid scratching!
TOOLS: Rubber mallet, Allen key (included), Adjustable wrench, Phillips screwdriver, Drill.
Helper is needed.
TEST THE COOLING UNIT:
Plug it in on a table top, to verify that controls and display are functional, and that the unit is producing cool air after a few minutes of operation.
Note that the electronic controller has a one-minute safety delay between initial plug-in and start-up of the compressor.
BEFORE YOU START: Fill out the warrenty registration form. You will find the serial number for the form located on the left side of the unit or on the light cord.