Mini Split 3000S Refrigeration System

Designed for wine cellars up to 600 cubic feet and rated for internal or external (see notes below) applications, CellarPro’s Mini-Split 3000S 1/4 Ton Nominal refrigeration system allows the noise from the condensing unit to be removed from living areas, and eliminates the need for large holes in your cellar wall. This is achieved by separating the evaporator unit from the condensing unit.
Our advanced evaporator unit uses a variable-speed centrifugal fan with three settings, including a “high” setting for maximum performance and a “low” setting for super-quiet operation. Inside the wine cellar, our evaporator should be wall-mounted near the top of the cellar with supplied mounting brackets, or remotely located and ducted when used with our front duct kit. Please note that the evaporator cannot be exposed to freezing temperatures.
In its standard configuration, our high-performance condensing unit will handle environments ranging from 40F to 110F. The condensing unit requires 12 inches of unobstructed space in front of the coils, and requires approx. 600-700 CFM of ventilation when installed in a confined space.
CellarPro Split wine cellar refrigeration systems offer a choice of wiring:

1. The Condensing unit can be electronically controlled by and wired to the Evaporator (single power source on the Evaporator side). This configuration allows the Condensing unit to be used in temperatures down to 20F with the addition of our compressor heater, or >-20F with the addition of our low ambient kit. This configuration requires a 15-amp dedicated circuit breaker for 3000S and 4000S systems, and a 25-amp dedicated circuit breaker for 6000S and 8000S systems.
2. The Condensing unit can be controlled by a Solenoid valve (dual power source, one each to the Evaporator and Condensing units.) This configuration allows the Condensing unit to be used in temperatures down to 20F with the addition of our compressor heater, or 0F with the addition of our low ambient kit. This configuration requires the evaporator to be wired to a 15-amp circuit breaker, and the condensing unit to be wired to a dedicated 15-amp circuit breaker for 3000S and 4000S systems, a dedicated 20-amp circuit breaker for 6000S systems, and a dedicated 25-amp circuit breaker for 8000S systems

Important Notes: To activate your warranty, you must complete and return our Installation Checklist. External installations require our outdoor hood (sold separately). For exposure to environments below 40F, our compressor heater modification is required. For exposure to environments below 20F, our low ambient kit (which includes a compressor heater) is advisable. Access to the left and right side of the evaporator unit is required for installation. All split systems must be installed and charged on site by a qualified HVAC professional. Line-set equivalent feet must be calculated in accordance with ASHRAE guidelines; refer to our Line Sizing Chart for more information.